1 / 3
Victoria Miniatures Matilda battle tank turret magnet jig — zdjęcie 1
1 / 3

Victoria Miniatures Matilda battle tank turret magnet jig

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The VictoriaMiniatures Matilda battle tank has insets for magnets in the turret base and sponsons but none for the…

Ocena
0 / 5
Polubienia
1
Pobrania
15
Wydruki
0
Wyświetlenia
490
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The VictoriaMiniatures Matilda battle tank has insets for magnets in the turret base and sponsons but none for the turret weapons.

This is a jig for centering drill holes in the turret and weapons so the magnets in each align to the other. One side is a jig for the turret and the other is for the weapons.

Instructions:

  1. Print the jig.
  2. Insert jig into turret. Push a 1mm drill bit through the hole and drill enough to establish a foothold for a larger drill bit.
  3. Remove the jig and use a drill bit that matches your magnets to drill a hole deep enough to hold it. I opted for 4mm x 2mm cylindrical N52 magnets and so used a 4mm drill bit.
  4. Put a weapon into the jig and use the 1mm drill bit to mark the center.
  5. Repeat 3 and 4 for each weapon.
  6. Glue in some magnets. Make sure to get the polarity right!
  7. Have fun.

Print Settings

Rafts:

No

Supports:

No

Resolution:

200

Infill:

20

Filament: PolyMaker PLA

Category: Vehicles

Tagi