1 / 6
Face Shield Headband for 1.2mm large nozzle (20 Minute Print!) — zdjęcie 1
1 / 6

Face Shield Headband for 1.2mm large nozzle (20 Minute Print!)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix to Print FAST with a large nozzle. Edit 3: rc1-13mm-v01-warch.stl now only 13mm tall. Front hooks extended 1mm.

Ocena
0 / 5
Polubienia
1
Pobrania
60
Wydruki
0
Wyświetlenia
508
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Remix to Print FAST with a large nozzle.

Edit 3: rc1-13mm-v01-warch.stl now only 13mm tall. Front hooks extended 1mm. Side/rear hooks extended .5mm but shaved 1mm off the back side. (material was building up, making it hard to attach the shield) Removed tabs and now just using 2 skirt loops (less trimming)

Edit 2: Ver rc1.9-5tabs-no-arch.stl cut out the arch in case you want to nest parts on the bed.

Edit 1: Ver rc18-5tabs-n-arch.stl updated with more adhesion tabs. The "arc" is added to prevent any skirt/brim inside the headband.

V1: rc16-new-tab-no-arch.stl Removed letters & Hex holes. Added adhesion tabs.

Print instructions

Print 40-60 mm/sec ~ 240c using MH Build PETG
1.2mm nozzle in the MOARStruder cranks these out!
0.55 layer height
1st layer speed <800
ZERO Infill - not needed

Tagi