8mm Spinda probe mount for E3d Hemera or Trianglelab matrix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
8mm Probe Holder for Hemera Extruder Fan Side
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 249
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a mount for an 8mm probe for a hemera/matrix that goes on the fan side. (I used super Pinda the best!)
The reason I put it on the fan was because I wanted a grill for the fan anyway. I have accidentally put my finger in the fan a few times on hemera/matrix and was not happy with that.
The actual probe holder is not my design… it is from the EVA 2.4 github.
The shroud does block the flow of air to the fan slightly but I haven't had any problems with heat creep so far. I am printing at max volumetric with a .6mm and .4mm layer height so your results may vary.
--------------------
Fasteners Bom:
5 QTY: M3 x 5mm OD x 4mm L heatset inserts as used on voron builds
2 QTY: M3 x 10mm L SHCS for the EVA probe mount
3QTY: M3 x 6 for putting on the bracket.
2 QTY: M3 x 12mm L for installing the fan and shroud (may need to substitute depending on fan)
-------------------
Please note: I did tap out the screw holes on my matrix to a M3 x .5 machine screw thread. I was not happy with the self tapping screws that were provided. Tap at your own risk, as blind holes are not easy to tap.