Bambu X1 Lid Lift Kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Safely and securely vent the top of your X1 with the AMS still on top!
- Ocena
- 4,5 / 5
- Polubienia
- 119
- Pobrania
- 466
- Wydruki
- 4
- Wyświetlenia
- 4424
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This print raises the glass top safely and securely for ventilation and can handle the weight of the AMS on top. It has the same footprint as the actual glass in the corners so when the printer is shaking, it'll hang on.
Print with PETG or ABS, 5-6 perimeters, and 30-ish percent infill. I prefer support cubic. The goal is strong perimeters and mild heat resistance, though PLA would probably be ok for PLA only printers.
Uses ¾" wide by 1/8" thick foam tape to grip the glass. Put the tape on the bottom of the slot and trim it up to look nice.
I'm only sharing the step files right now, if you wanna make them taller, you can just extrude the bottom surface down however much you need. Also, Bambu Studio and PrusaSlicer both accept step files natively, and usually produce nicer prints.