SAO night sky sword
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
this version is tested and makes a full sword. the pommel screws on a M8 thread so you can use this to make the blade…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 536
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
this version is tested and makes a full sword.
the pommel screws on a M8 thread so you can use this to make the blade stronger over the whole lenght.
the smaller holes next to it are to make alignment easier with assembly.
This is one of two versions i made of the night sky sword from sword art online.
This one has the thck blade it is 2cm thick
i also uploaded a 1cm thin version because nobody knew what looked best.
if someone made it please share it so we can see the differences
it is cut up to fit a CR10S because this is what i use.
Category: 3D Printing