Flyingbear Reborn 10mm External Motor Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Versions: PoC Add more rigid making it a good fit Make it more rigid, slightly increase the size by 3 mm, and move the…
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 721
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Versions:
- PoC
- Add more rigid making it a good fit
- Make it more rigid, slightly increase the size by 3 mm, and move the Left motor down by 3 mm. Add a hole for the belt tensioner.Have misplaced wall hooks - deleted
- Add wall offset for a vertical profile to increase fit
- Make it pretty and make the bolt tensioner more robust
move L motor down by 10 mm to make it in line with a belt and allow to flip pulley on motor shaft. 6. Make it as low profile as possible (+-54мм out from wall), make it wider, use an internal profile for bolts mount, and make it rigid like crazy (you can lift printer by them).
Print Settings
Printer:
FlyingBear Reborn
Rafts:
No
Supports:
No
Resolution:
0.16
Infill:
20%-30%
Filament:
eSUN PLA+
Red (orange)
Notes:
Can be printed with no supports (and enough cooling) on the flattest side, approximately 50g per adapter.
1.6-2mm per wall will be ok, about 1 mm for top/bottomCategory: 3D Printer Parts