Biodogradable Dog Bag Dispenser

I use the "Biodogradable" brand of dog poop bags, which tends to run a bit larger than other brands (it also doesn't have the little tube "spool" in the middle). This means that most of the bag dispenser designs on Thingiverse don't fit these bags. This model should hold bags up to 70mm in height and ~42mm in diameter.

I really liked bandslinger's design, but just scaling it up wound up with super thick walls. The only model that's directly copied from bandslinger's version is the loop (and I shaved the "spike" off of that), but you can clearly see that most of my design wound up being similar to that one.

Note: I purposely left a "ring" below the threads inside the cap, the idea being that you could add an o-ring here if you had issues with the cap coming unscrewed (my previously printed dog bag holder had this issue), so far this design seems like it stays screwed on it's own, so time will tell if I wind up needing that o-ring or not. Due to the extra overhang of the thread "starting", you may wind up with some extra strands in the top of the cap that will need to be trimmed off.

Note: The ring is a pretty tight fit on my printer (doesn't even need glue to stay in place) , so you may need to scale it up or down slightly depending on your setup. I'm also using a .6mm nozzle whichmay affect things like how sharp my corners are, but in general it shouldn't affect the dimensional accuracy too much. Hopefully it works without too much fiddling for most people.

Category: Pets