STI Superlink RX / Hybrid 98 Cryocooler Jacket (1/4 NPT fittings)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed this to accept 1/4 NPT fittings and increased the hole size for the original power cable (you will have to…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 465
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
I remixed this to accept 1/4 NPT fittings and increased the hole size for the original power cable (you will have to unpin the wires from the connector and then repin them after putting them through the hole).
Do noteYOU MUST TAP THE HOLES YOURSELF. The holes are sized 7/16 with an additional 0.6% diameter for shrinkage (PETG shrinkage standard).
PETG is a must if you want to use this on your own Hybrid 98 to ensure waterproofing. However, I still added a thin coat of resin epoxy on the inside to guarantee no leaks.
Once you have a good coating, bring the 2 clamshells together and secure them with marine grade epoxy or silicone. In my case, I am using marine epoxy to mate the 3d printed surfaces together and silicone to attach the jacket to the Hybrid 98 top/bottom.
If you wish to have the source files, please leave a comment. I can not upload them directly.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.20
Infill:
100%
Filament:
Prusament PETG
Notes:
Rafts weren't needed, but your printer may not perform as well.
A thin layer of resin epoxy shall be added to all inside surfaces.
Category: Parts