Z brace frame support Anycubic i3 mega S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
09.17.21 updated the top brace adapter for the top hole clearance.…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 702
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
09.17.21 updated the top brace adapter for the top hole clearance.
//----------------------------------------------------------------------------------------------------------//
Z brace for the anycubic i3 mega.
Will require drill into the sheet metal. M5 screws, washer, & nuts are needed. Needle nose pliers will help with the bottom nut, due to tight space.
This is pretty much the final revision. 1 more designs will be upload but not critical for installation.
A digital protractor will help square up the gantry when tightening down the top brace. It's sort of a needed tool to line everything up.
I had all my electronics removed from inside the case, not terribly difficult to do. Metal shavings will get everywhere, be aware of that.
Print Settings
Printer Brand:
Anycubic
Printer:
All-metal Mega
Rafts:
No
Supports:
No
Resolution:
.16mm-.20mm
Infill:
16%-20% triangle with higher infill flowrate for thicker infill lines
Filament:
Any Any
Notes:
Mirror the it for the other side.
Does not need supports.Category: 3D Printer Parts