ThumP: A Runcam Thumb Pro Mount (open source)

This is a Mount for the Runcam Thumb Pro, based off the rather nice looking model by JoyMonkey (available here: https://www.thingiverse.com/thing:5433478).

I plan to make some various other mounts for this camera,so stay tuned, and don't be afraid to make a request!

I am Including the .sldprt file, so if you have access to Solidworks you can easily change the features and dimensions to your liking, all that I ask is that you link back to this page, and contact me before selling/producing these models commercially! 

I have also included an .stl and .step of the following models for use in other CAD programs:

Thump V2.1: Now with USB port, cooling vents, and either a cutout for the button, or a flexible section that allows you to press the button through the front wall. Previous configurations will be updated with V2 features in the near future, and will reflect it with "V2" in the name. V2.1 has Solidworks configuration manager working with most types in one file.

Jello Wrangler: Experimental Version with extra support for the lens to reduce vibrations. Feedback on this is greatly appreciated so that I can get it just right for everyone; front to back vibrations are much better, but still deciding how much the side to side vibrations need to be tamed.

Vertical V2: Vertical with lens/shroud at bottom

Periscope V2: Vertical with lens/shroud at top (may be a bit flexy, I'm working on a solution though. Try it and give me feedback!)

Thump-Lite V2: Lens shroud is removed for weight savings.

No Tabs V2: has relief cutouts but no tabs (for adding your own fastening designs)

Older V1 Configurations:

De-Featured: No tabs, vents or rear entry relief cutouts, so you can modify the design from a very basic state. (Don't print this, you wont be able to get the camera in, or more importantly, back out if you do manage to force it in)

Thump Ultra-Lite: Like the Thump-Lite, but with 1.2mm walls instead of 3mm for even more weight savings. ~4.5g

*********This is an ongoing project, so feel free to remix or fix this (for non-commercial use)!*********

Print Settings

Rafts:

No

Supports: 

Yes

Resolution:

.2mm

Infill: 

20%, 1 wall. Only increase if you REALLY need the extra strength.

Filament: any TPU 95 A any

Notes:

This was designed with .2mm layers and .4mm line width in mind, might work with other layers heights though. Going low on the wall count and sparse infill seems to give better cushioning while still being plenty stiff. Cubic infill gives a nice pattern with transparent filaments.

**Switch filament color to black a few layers before the final lens shroud chamfer to completely eliminate the possibility of glare from bright filament colors.**

Post-Printing

Category: Camera