Monitor Remix for M.NT68676.2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A couple years ago I took apart an old laptop and bought the M.NT68676.2 driver board online. I made a terrible…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 405
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
A couple years ago I took apart an old laptop and bought the M.NT68676.2 driver board online. I made a terrible monitor case out of the laptop, some parts from a stereo receiver, and tape and glue. I recently had a reason to use it and remembered I have a 3D printer now.
I printed out everything for Make a Monitor with Old Laptop, but found the covers for the board and buttons didn't fit mine. I redesigned them to use the same mounting holes but fit my parts, and its pretty ok. Feel free to edit or adjust yourself, ipts are provided for the parts I remade. As I was trying to use the same mounting holes as the original, one post covers the vga port, but all I needed was hdmi so that was fine for me.
My monitor is an LP156WH2. Unfortunately I couldn't squeeze it completely flush into the case, so some of the mounting holes didn't line up perfectly and I needed to dremel in a couple new holes to mount everything.
The symbols on the button cover came out much nicer on an earlier part I printed, but I ran out of that filament and needed to make the housing deeper.
https://www.ebay.com/itm/361629777025 Driver board I used. There seems to be some variants with an a after the name with some connectors in different places, as well as another variant that has 3 total boards instead of 2
Remix from https://www.thingiverse.com/thing:3448696 Other models from that link are required to use this
Category: DIY
