TS100 Stand Form
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a form to bend a 2.5-3mm wire into a coil as a stand for a ts100 or similar soldering iron. I used a cloths…
- Ocena
- 5 / 5
- Polubienia
- 41
- Pobrania
- 90
- Wydruki
- 4
- Wyświetlenia
- 944
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a form to bend a 2.5-3mm wire into a coil as a stand for a ts100 or similar soldering iron. I used a cloths hanger, but sanded the paint off first so the hot iron wouldn't burn it.
After forming the end can be cut with a hacksaw to make unscrewing it easier. The offset top makes it harder to unscrew without deforming. You could try cutting it apart before unscrewing. I may post a two piece design if there are any requests.
Print Settings
Rafts:
Doesn't Matter
Supports:
No
Resolution:
2.8
Infill:
30
Notes:
at least 3 perimeters and 30% infill to make it stiff enough. I used PLA, but anything should work.
Category: Electronics