HeaterMeter v4.3.6 TC and RPi Zero W Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case designed for HeaterMeter v4.3.6 with thermocouple option and Raspberry Pi Zero W
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 417
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Edit 10-18-22: I've got to make some changes to this design. The case eventually became warped on the front (I believe due to where the screws are applying pressure on the case without adequate support).
The official HeaterMeter 4.3 case is a great design, but I've made some changes: removed the unnecessary additional space at the top of the case when using a Raspberry Pi Zero W, made a fully bolted together design using cap screws, and added additional support for the boards.
I was unable to find solid or even 2D file formats of the original HM case so I basically designed this one from the ground up. I first started in AutoCAD using board layout drawings, and then moved it over to Fusion 360 for the 3D design. I've also included the STEP files so feel free to remix however you want!
Hardware needed is four (4) M3x30mm cap screws, and four (4) M3 nuts (either hex or square nuts can be used in this design). You can alternatively use 25mm screws for the top two screws.
Though this is technically not a remix since it was a ground up design from scratch, I feel like I should give credit to CapnBry and his official HeaterMeter v4.3 Case design: https://www.thingiverse.com/thing:1700586