Ikea PLATSA spool holder V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple spool holder to fit the Ikea PLATSA closet.
- Ocena
- 4,818 / 5
- Polubienia
- 94
- Pobrania
- 794
- Wydruki
- 21
- Wyświetlenia
- 3182
- Oceny
- 22
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
A simple spool holder to fit the Ikea PLATSA closet.
My previous design had a filament guide to it, but for the sake of reusability and flexibility, I found it better to make that into a separate part.
Spool requirements:
Minimal inner diameter: 50mm
Maximum spool-width: 80mm
Verified to fit the following spools (but obviously not limited to, I'm yet to get a spool that doesn't fit):
- Prusament (1kg)
- PrimaCreator (1kg)
- ColorFabb (750g)
- Azurefilm (1kg)
- Esun (1kg)
- Sunlu (500g)
- HobbyKing (1kg)
- Anycubic (1kg)
- 123-3D (1kg)
- Real Filament (500g / 1kg)
- Eryone (1kg)
If this helps you out, please like, rate and/or share a picture of the result! Otherwise, please leave a comment with feedback 😉
Changelog
- 10 dec 2020
- Removed spool-holder.stl
- Added spool-holder-preoriented.stl (same stl as before, but oriented in a way that no orientation change is needed when opening in PrusaSlicer)
- Added spool-holder.3mf (print profile + stl)
- Added gcode for MK3S
Print instructions
[email protected] layer height, 15%+ infill, with 3 perimeters. Orientation as pictured.