Bambu Lab X1-Carbon Transporter (handles)

Now you can transport your X1-Carbon without having to call in a favor. Get some leverage when you have to move your X1-Carbon to a new location. Since the X1-Carbon has no handles or other safe way to carry the printer when you have to move it, I created the X1-CarbonTransporter (handles). 

For those of you who do not trust their filaments layer adheasion properties, I also give you the Steel Reinforced X1-Carbon Transformer (handles)! 16 M3 steel screws to prevent any possible issue with layer adhesion. Six 25mm M3 screws to keep the blocks in place. Ten M3 screws of 10, 15, & 20mm lengths that are tiered up each handle side to secure the Transporter handle to the base. These screws X 2 for both handles, and 31 M3 threaded inserts for the bottom of each handle plate (15 on one, 16 on the other). If you go this route, print two handles and one of each of bases that don't have handles.

The bottom of the printer has two rows of ‘pockets’ along the front and back of the printer that the Transporter (handle) blocks slide into. There are no mechanical, electrical, or structural components that prevent these handles from being used to help secure the printer in your arms when you need to move it.

There is one unique STL for each side, and are labeled to place them correctly in the front left corner and back left corner of the printer. Carry the printer by lifting on the handles from the opposite side (door opens facing you). 

50 pounds is a lot of weight, so be careful! 

Printed in PLA+ with 3 perimeters and 30% infill. Support needed for handle grip. 
.3mm layer height for a .6mm nozzle or .2mm layer height with a .4mm nozzle.