Buildplate Direction Test
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
I replaced the stock board of my CR-10S with an SKR mini E3 V2 board and reconfigured the firmware, and then ran into a problem. Some of my prints were coming out with inverted geometry. I thought that maybe the slicer was configured wrongly or maybe the cables were flipped, but that wasn't it. Turns out I had inverted the Y-axis and Y-endstop, so the prints were being mirrored about the Y axis.
I made this test while I was troubleshooting to determine which way things were being printed. The first one came out with L and R on the correct side, but up and down flipped. After fixing the firmware, it came out correctly.
Should print with any print settings really. I printed it with the standard printing settings and 100% infill.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
200
Infill:
100
Filament: Hatchbox PLA PLA Blue
Notes:
Make sure you don't rotate it in the slicer.
Category: 3D Printing Tests