Ender 3 Geared Extruder (mostly stock parts)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An older version of a geared extruder setup I designed for the ender 3, which uses most of the stock hardware
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 407
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
An older version of my current custom extruder. The only non-stock ender 3 parts (besides what is printed) is the all-metal dual-gear extruder kit that's everywhere on amazon (an example link below, theres loads of clones), some bearings, a 5mm shaft and an assortment of screws. I have included instructions in PDF form.
Print with at least 3 perimeters with a 0.4mm nozzle
I advise anyone CAD savvy to try it as-is then make any improvements they see fit. I've made a few tweaks but its fine in this config. Bonus points if you can get the cooling duct resin printed, as my PETG one kept sagging
Extruder replacement: https://www.amazon.co.uk/Redrex-Extruder-Creality-Filament-Supported/dp/B09H6T3NNT/ref=sr_1_5?keywords=ender+3+dual+gear+extruder&qid=1665777265&qu=eyJxc2MiOiI0LjEwIiwicXNhIjoiMi45NiIsInFzcCI6IjIuNTYifQ%3D%3D&sprefix=ender+3+dual%2Caps%2C62&sr=8-5