Ender 6 X&Y MGN9 Linear Rail mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ender 6 X&Y MGN9 Linear Rail mod. Fully compatible with Creality top cover movable Y endstop mount
- Ocena
- 0 / 5
- Polubienia
- 34
- Pobrania
- 305
- Wydruki
- 0
- Wyświetlenia
- 2961
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Ender 6 X&Y MGN9 Linear Rail mod.
- Fully compatible with Creality top cover
- movable Y endstop mount (you can set from 250 mm to 275 mm. If you cut Z screw by 2-3 cm and have PEI you can set Y enstop even to 290 mm)
- Use many stock screws
I edited few existing mounts for my needs and gather it as one bigger project.
Warning! This is not a easy mod!
You need to loose X and Y motor mount before unscrewing everything. Check if everything is square before tightening the belts. Use light anaerobic glue to the screws.
Check if the Y mount rubbing again plexi panels. If so use sandpaper on the printed mount or add foam tape under plexi panels.
Parts needed:
3x 350 mm MGN9H linear rail
31x M3 freenut
42x M3X8mm
1x M5X12mm (right plexi panel screw. Or cut the existing one)
Original mounts Authors:
Y mount: https://www.thingiverse.com/thing:5237777
by anuwat_hokoon
X mount: https://www.thingiverse.com/thing:5411497
by Damudm (Remix of "Ender 6 Linear Rail Mount X Carriage
by Tertullidan")
Print Settings
Infill:
40%
Filament:
Generic PETG, ABS, ASA Category: 3D Printer Parts