1 / 5
Sunlu Filadryer S2 Filament Guide and Moisture Vent — zdjęcie 1
1 / 5

Sunlu Filadryer S2 Filament Guide and Moisture Vent

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A small clip to help guide the filament out of the front of the S2 dry box as well as ventilate the unit.

Ocena
4,714 / 5
Polubienia
58
Pobrania
430
Wydruki
10
Wyświetlenia
3913
Oceny
7

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

While the S2 is a good idea in principle, it has some drawbacks - the two filament exits in the shell are quite steeply angled, which does not work well when printing from it sitting at the same level as the printer itself.

Additionally, Sunlu forgot to add ways for the extracted humidity to exit the box, leading to high relative humidity inside the box - meaning it does not manage to dry the filament as-is.

To fix these issues, I designed a small filament guide which also serves as a wedge - hardly any temperature is lost through the gap, but relative humidity stays <30% inside the box at 50-55% RH in the print room. The filament guide clips onto the S2 case lip and holds itself firmly (the outer lip acts as a spring).

Print with 0.2mm layers or better laying flat on either side, 10% infill is plenty - but use PETG or another temperature-resistant material. PLA does not work.

I used a Capricorn XS bowden tube (~30mm) which fits snugly and has low friction, works much better now for me.