i3 8mm Leadscrew upgrade Z Axis motor mounts for 42mm high motors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Update 8/14/2016 I'm not using a top bearing for the leadscrews (right now), so I removed that bit to make the upper…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 129
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Update 8/14/2016
I'm not using a top bearing for the leadscrews (right now), so I removed that bit to make the upper shaft holders quicker to print. I widened the smooth rod hole by .3mm and added a strain relief gap as in the motor mounts.
I also added the missing anti-backlash nut recess on the right X-end piece and again widened the smooth rod holes by .3 mm
Initial Summary
I purchased these Z Axis motors with integrated 8mm Leadscrew - http://www.ebay.com/itm/142038182961, but the motors are 42mm high vs the 47mm of the original motors, so I increased the thickness of the mounts so I wouldn't have to re-drill the mounting holes on my frame.
Also, the smooth rod hole was a little small on the original, so I widened it by .1mm and added an expansion cutout.
Print Settings
Printer:
Homebrew i3 variant
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
.3
Infill:
50 - 70%
Category: 3D Printer Parts