Mercury 1.1 EVA Ender 5 Maximum Y brackets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Maximize Y travel on Ender 5, Mercury 1 with EVA
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 77
- Wydruki
- 1
- Wyświetlenia
- 831
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- GNU General Public License v3.0
These brackets allow you to get the maximum Y travel possible on the ender 5 frame. When converting an ender 5 to the ZeroG Mercury1 with the EVA tool head, some Y travel is lost because the rear mounted fan hits the Z guide rod brackets.
To maximize Y, you must first remove the unnecessary top & bottom 2020 extrusions that the ender 5 Z guides and stepper are mounted to. They can be mounted directly to the rear frame. This gives you 20mm more travel.
Then use these printed brackets to replace the upper Z guide rod brackets. They mount to the bottom side of ender 5 frame extrusion. The guide rods can drop down a bit as well. Now the EVA can travel all the way back to ender 5 frame. Reset your end stop and this will give you 275mm x 275mm travel.
I've included two versions, one uses a heat set insert and the other a nut.
Required hardware:
Four M5x10 or 12 screws to mount to frame
Two M3x 16 for the clamp
Two M3 heat set inserts or nuts