1 / 9
Black and Decker EU Battery Charger and Holder (v1)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a holder against a wall for Black and Decker Lithium Batteries. Version 2 is much better (see link below)
- Ocena
- 4 / 5
- Polubienia
- 12
- Pobrania
- 43
- Wydruki
- 2
- Wyświetlenia
- 543
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Public Domain
SzczegółyPliki (7)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (3)Kolekcje (17)Powiązane
Click here for Version 2 instead
It has two parts.
Main Body
- You can “push” the loader with its wire in the whole - push until flush with the other side.
- Then tuck the wire in the small gutter - chose any side you wish

- Once the holder is in place, you can “slide” from the top (the battery will rest on top of the holder)
Wall Mount
- Screw on a wall, the row with 2 holes goes “on top”.
- Look at the screw head indents for direction.

- The lip goes at the botom, pointing out from the wall

Slide your battery
- You can slide your battery and push until it fits in the charger.

- If place higher than eyesight, you will see (from the underneath part) the light indicators from the charger
Print format?
I printed on my amazing new Bambu X1 which got it out the the box right.
This being said,
- I printed in 0.24 layer height (PLA)
- 8 walls!!! Batteries are very heavy. That's a bit load on that small holder.
- Infill 50%
- It worked without problem with no support on my side (the bridges are all straight)
You might have to do with horizontal expansion (see below)

Enjoy!
