SOG PowerAccess Assist + OLight I3T Holster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holster/sheath for the SOG PowerAccess Assist and the OLight I3T.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 684
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
No supports required, print with the bottom of the holster on the bed. Only one prototype needed a (small!) raft. Final version printed with no raft in PETG but PLA/PLA+ would probably be just fine.
If the OLight is loose, use a heat gun to soften the plastic toward the base of the OLight where there's an indentation for the clip and pinch it in. Obviously be careful, but this lets you customize the fit to your particular printer and desired grab.
Next on the list is to add bit storage on the side opposite the flashlight.
Feel free to ask any questions or remix as you'd like to fit other tools.