Enclosure mounted 7" touch display (Sunfounder)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed to mount my 7 inch touch screen to my prusa enclosure (v2), so I designed this case with 90° tilted mounting…
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 375
- Wydruki
- 0
- Wyświetlenia
- 2470
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I needed to mount my 7 inch touch screen to my prusa enclosure (v2), so I designed this case with 90° tilted mounting mechanism. Mount the base plate to the lower lack table, either left or right (your choice). Use the power cable whole at the back to put the USB and HDMI cable through into the enclosure.
This is the display I used:
https://www.amazon.de/SunFounder-Raspberry-Display-kapazitiven-Touchscreen/dp/B07YZ3ZVTW
You need to print the screw ("schraube.stl") twice.
Screw and nuts used:
- 4x M3x6
- 4x M3x16
- 8x M3 standard nuts
Use acclaimed screw for nut pull into whole technique.
Print instructions
Best printed with Prusament PETG
- 0.2mm layer height
- 30% infill (gyroid recommended)
- Support on build plate only (use sharp knife to cut of the support after printing)