Terminator-A Well Documented Antweight Combat Robot

This is Terminator, a drum spinning destruction bot.

*All use is at your own risk I will not be liable for and damage and/or injury.

Here is the scoop version: https://www.printables.com/model/299306-terminator-scoop-version 

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 Pro

Rafts:

No

Supports: 

No

Infill:

100%

Filament:

N/A Nylon

N/A

Notes:

Made to be the boss of the arena.... Articulated forks made to always scrap the ground.

Post-Printing:

Step 1: Installing Drive Motors-1

Drill holes in where the screws go for fingertech motor mount.

Step 2: Installing Drive Motors-2

Install fingertech silver spark 30:1 of 50:1 motors. Connect to fingertech tiny esc's and FlySky FS-IA6B receiver.

Step 3: Power Light

Drill hole in top plate for LED power light. Use hot glue underneath the top plate.

Step 4: Weapon Part-1

Drill in fingertech 4mm shaft motor and connect to BL-Heli 20A Brushless Speed Controller and receiver.

Step 5: Weapon Part-2 (optional but recommended)

Hot glue 4mm flanged ball bearing into opposite side of motor for shaft to rest in.

Step 6: Weapon Part-3

Attach clamping drum assembly to motor.

Step 7: Wheels

Attach 3mm bore .5 inch fingertech twist hub pair to both motors. Then put on 2.00x.5in wheels.

Step 8: Articulated Jaws

Attach 4 articulated jaws so that they can always scrape the ground. I used small zip-ties tightened just enough and pointed down

Zip-tie photo

Step 9: Wiring

Connect all the wires as shown using fingertech terminal block red wires in red block, black wires in black block. For motors plug in miniQD ends that can come on tiny esc's. For receiver drive esc's go into slots 1 and 2 and weapon goes into slot 3. If certain one does not work just flip the way it faces.

Step 10: Set remote settings to those shown below.

Remember the FlySky FS-I6X has a weird quirk were you need to hold cancel to save settings NOT press ok. To get to Mixes and Reverse hold ok, press up, press ok, and scroll up or down until you find them. In the case of reverse it is right on top.

Mix #1

Mix #2

Reverse

Step 11: Go, Go, Go

Plug in a 3s 450mah batter from fingertech website. Drive it and have fun.

Step 12: (1/4 of the time this is not applicable)

If motor goes wrong way switch witch way the miniQD connectors going into it.

Category: R/C Vehicles