Cricut Maker Tray Extension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was getting frustrated with my mat constantly flopping onto the floor before/after cuts, so I made these extensions
- Ocena
- 5 / 5
- Polubienia
- 204
- Pobrania
- 792
- Wydruki
- 4
- Wyświetlenia
- 4483
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I was getting frustrated with my mat constantly flopping onto the floor before/after cuts, so I made these extensions to bump out the tray just enough to support a standard 12x12 cutting mat.
You can print and many or as wide of clips as you'd prefer. I have two at 15mm wide which is more than sufficient, but I may print a 3rd for the middle. The fit around the existing tray is pretty close but there's no actual attachment mechanism so I used a tiny bit of sticky tack on the front of the existing tray/inside the extension to make sure they don't get bumped around.
There is a bit of a flaw to the design - if you end up cutting to the very bottom edge of a 12x12 sometimes the mat will catch on the extensions. I've mitigated this with a piece of tape between the tray and the lip occasionally, but for most cuts the extensions work just fine.
Note: you cannot open the compartment in the tray with these clips on, so don't attach them permanently if you want to use said compartment.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.20 mm
Infill:
20%
Filament: Hatchbox PLA White
Category: Machine Tools