Expert Painting Handle

All other painting handles I could find was too cumbersome to use, and required rubber bands to hold the miniature. They were also too wonky when the miniatures is attached, and the miniatures can slide out. Even the store-bought once were such bad design the obstructed the access to the miniatures

So I spent a shit-ton of time designing this paint handle. It:

• Is just the right size for your hand
• Holds the miniature really secure
• Doesn't obstruct the view/access from below
• Can be used straight out of the printer, with no extra assmbly
• Prints fast (less than 1.5 hours)
• Can be scaled to any base size (square, round, you name it)
• Works very well with airbrush (airbrushing from below)

There are different attachments for gripping the different base sizes. So far I've added 25mm, 28mm, 32mm and 40mm. 

I've also added airbrush attachments. The reason I use these almost exclusively is that they give very good control for painting the miniatures from the bottom as well. They also have a magnet hole, so you can use a steel spraying stick.