RatRig Vcore 3.1 EVA3 Orbiter 2.0 Duet Toolboard 1LC
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Duet 3D Toolboard 1LC holder to connect to the EVA3 system and add stability.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 42
- Wydruki
- 1
- Wyświetlenia
- 984
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
I made a Duet 3D Toolboard 1LC holder to connect to the EVA3 system and add stability. I added an arm that screws directly into the Orbiter screw, just use a longer M3x30 screw to connect the orbiter to the board back.
Apologies if this design is not very good, i made this quick and prototype only. I can make changes if requested and they are worthwhile.
I used the smaller cable holder from another design which i added as remix, but no changes were made to that part.
Print Settings
Print in the orientation shown in the picture of this post.
You will use a very small support just for the back piece. I printed in ABS.
0.2 mm layer height,
supports yes - build plate only.
Print Settings
Rafts:
Doesn't Matter
Resolution:
0.2
Infill:
20