1 / 1
Edgun Leshiy Double M-LOK Magazine Holder — zdjęcie 1

Edgun Leshiy Double M-LOK Magazine Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A double magazine holder for the Edgun Leshiy, a compact PCP rifle.

Ocena
0 / 5
Polubienia
13
Pobrania
217
Wydruki
0
Wyświetlenia
1499
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

This is my redesign of the edgun leshiy magazine holder for use with M-LOK rails. I have a single mag holder version up here as well.

This version has some subtle improvements over the original design. It is intended to be printed in PLA+ for the correct spring tension and strength. You should also use a 0.1 or thinner layer height as there are a couple of angled sliding surfaces that are important to operation and a thicker layer height will causing a less smooth operation.

This mag has double spring action for a more secure hold, as well as a beveled catch for an easier twist release. It also will hold two magazines and mounts at an offset on the slots as necessary.

I would recommend printing without a brim and with supports. The recesses for the underside are important to the operation as this model doesn't include the M-LOK rail alignment guide so it will print flat.

happy plinking!

Tagi