OctoPrint Control Panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted a little control panel mounted on my CR-6 that showed print status, ETA and other metrics from the print,…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 355
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I wanted a little control panel mounted on my CR-6 that showed print status, ETA and other metrics from the print, printer and Octopi system. This leverages off-the-shelf protoboard, an inexpensive OLED screen and some simple tactile buttons plus a compliant print to wrap it all up in a tidy package that slides on to the 4040 extrusion right next to where my Pi is mounted.
Other designs I've seen for an Octoprint OLED screen all used an ESP8266 to remotely monitor the print. Those are cool looking and I love the ESP line of chips, but I really wanted something directly connected so it could get immediate events and feedback, as well as act as a pause and cancel control.
This pairs with an OctoPrint plugin, available on my Github
Check out a demo here
I've been using this for about a week before posting to see if I needed any tweaks and it's pretty great right now. I'll publish updates if I rev this to Mk3.
Print Settings
Printer:
Creality CR-6 SE
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Filament:
3D Solutech PLA
Natural Clear
Notes:
Use the layout shown in the photo set to place the correct faces on the bed. This was designed to print without a brim or supports.
Category: 3D Printer Accessories