Apple 3-in-1 MagSafe Charging Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A charging stand to support MagSafe Apple products - iPhone, Apple Watch & AirPods!
- Ocena
- 0 / 5
- Polubienia
- 28
- Pobrania
- 171
- Wydruki
- 1
- Wyświetlenia
- 2154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I've recently completed my set of Apple products with the newest iPhone to accompany my Apple Watch & AirPods. In looking for an elegant solution to charge all 3 at my desk, eveything I found was either too big or didn't display the screens in a way that I liked. So I got to designing my own!
There are 2 parts to this design - the “Arm” which holds the Phone and Watch chargers, and the “Base” which holds the AirPods charges. The two connect via 2 M4 heat-press inserts and 2 M4 screws. This is so that you can adjust the angle to your liking, then lock it in place by tightening the screws. The back and bottom also has some channels for cable management. I ended up adding some tape over it all just to keep it more tidy (you never see the back anyway).
Printing was quite easy - 0.20mm layer height with a 25% infill seems to work just fine. For the “Arm”, I suggest printing with the charger faces down, which means supports are needed for the charger recesses.
The final product is quite light. I added some adhesive rubber feet to the bottom of mine to keep it from slipping as I detach the phone. This seems to provide enough friction to overcome the magnet's strength.
I hope you enjoy this and find some use for it! I'd love to see your makes and please don't hesitate to reach out with comments or questions!
Happy Printing!