Spotted Fiberoptic Mushroom Lamp

This remix adds a smooth mushroom cap with 7 holes for the 3 mm fiber optic cables to make a spotted mushroom. Set up electronics like the 7-Tentacled Fiberoptic Mushroom, but instead run the cables through the holes in the cap.  Be sure to cut the fiberoptic cables extra long to allow room to work, don't pull them all the way through cap initially.  It is tricky to screw the cap on while the cables are connected.  Rotate cap counterclockwise until cables are taught, then slowly pull each one through the cap a little at a time until the cap can be screwed onto gill.  Be careful not to pull the cables out of the puck that holds the Neopixel else you will need to start over on the cables.  Finally, with flush cut clippers trim the fiber optic cables near the cap, leaving about 1/8" hanging out for best visibility. Use 200 scale factor in slicer for mushroom, gills, cap and steam. For fiber light puck use 100.