Ergodox EZ Wrist Rest with customizable height and angle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After failing to find (or design) a comfortable wrist wrest ever since I bought my Ergodox EZ I think I've finally…
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 27
- Wydruki
- 1
- Wyświetlenia
- 428
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
After failing to find (or design) a comfortable wrist wrest ever since I bought my Ergodox EZ I think I've finally made a design which does the job well.
The left and right wrist rests are printed as is. The supports are printed depending on what you want. Zero to three stacks of supports are recommended per half, based on your configuration. You can start out by printing lower layer numbers and print additional layers as needed while trying out different configurations of the stacks. The layers stick well together, but you could add a layer of glue if you want a more permanent solution.
The L shaped cut is a convenient place to store your paperclip for reprogramming the keyboard.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
.15 mm
Infill:
10%
Filament: add:north E-PLA Marble
Notes:
There is a small print error in the picture where there is a visible border in the wrist rest holder. This is not part of the model.
Category: Computer