1 / 3
Cold Brew Kit for AeroPress
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3-part adaptor to turn an Aeropress coffee maker into a cold brew setup.
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 155
- Wydruki
- 0
- Wyświetlenia
- 2199
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (60)Powiązane
A 3-part adaptor to turn an Aeropress coffee maker into a cold brew setup.
You will need a sport-style water bottle (300ml to 500ml) with the type of valve that you can open with your lips. this type of valve allows you to adjust the drip rate to approximately 1 drop per second. You will also need the cylinder and filter cap parts of an AeroPress coffee maker.
- Print the 3 parts
- Press the cut-off bottle into the printed bottle holder
- Put some water in the bottle and adjust the valve to give 1 drop per second. Tip any remaining water away.
- Put a filter paper in the Aeropress cap and screw the cap onto the cylinder
- Put the aeropress on a mug, filter down
- Put 15g - 30g of medium ground coffee into the Aeropress
- Drop the drip spreader on top of the coffee
- Press the bottle and holder onto the Aeropress and fill with desired amount of water
- leave to drip through (takes about half an hour per 50ml) then enjoy your cold brew!
Adjust the amount of coffee and water to suit your taste.
Print instructions
Use a food-safe filament (I used polypropylene on MK3S)
nozzle 0.4mm
layer height 0.2mm