Carrera digtal - Stackable Lego compatible bridgepier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Carrera digtal - Stackable Lego compatible bridgepier
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 403
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a stackable Lego compatible bridge Pier thats meant to go under the Lanes of a carrrera digital 1/32. For the Lego bricks to fit (in my case because i had a little elephant foot) you need to nearly melt the Printed ,,Bricks'' on the side of the Part. Then press a 2x4 Stone in it to make the fit perfect. Under the Lanes there is a cross wich i have modeled a negativ of into the Part. From my knowledge curves, and straights have this cross on them.
ATTENTION Be carefull with your retraction settings so your printer doesnt retract at a corner. That has a big impact on stability.
Print settings:
Material: Anycubic PLA 220C nozzle 65C Bed
Layer Height: doesnt matter
Print speed: wouldnt go over 80mms
Support: you dont need it
Rafts: none
Build plate adhesion: none
Infill: 100% (that its holding strong)