Samsung tab s6 stand with pogo pins
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This stand has cutouts for pogo pins (small cobber pins with build in springs) that connect to the 4 small, round…
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 86
- Wydruki
- 0
- Wyświetlenia
- 1267
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
This stand has cutouts for pogo pins (small cobber pins with build in springs) that connect to the 4 small, round cobber plates in the bottom of the tablet.
On the pictures you can see i used some double sided tape to fasten the mount to the table. This is just to keep it from sliding around when i insert the tablet. its not needed.
When facing the tablet screen, the left pad is +5v and the right most is ground. I just used an old usb cable and cut the one end off, and then soldered the wires to 2 pogo pins. Then used a glue gun on the bottom of the pins to act as isolation and protection.
Its not fast charging, actually its pretty slow charging, but its enough for me.
Print instructions
print on the side. Use pla :)