1 / 1
Railcore Aluminum Y Carriage Belt Retainer for Nuts and Heatserts — zdjęcie 1

Railcore Aluminum Y Carriage Belt Retainer for Nuts and Heatserts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of https://www.thingiverse.com/thing:3423355 by Patrick Crawford and of…

Ocena
0 / 5
Polubienia
0
Pobrania
8
Wydruki
0
Wyświetlenia
98
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a remix of https://www.thingiverse.com/thing:3423355 by Patrick Crawford and of https://www.thingiverse.com/thing:3597877 by Emma Puggle. Be sure and print with the thin side down as Emma Puggle suggests for the maximum strength. The remix uses the heatset inserts by Initeq available here https://www.amazon.com/initeq-M3-0-5-Threaded-Inserts-Printing/dp/B077CJV3Z9 and the wide square nuts available here https://www.amazon.com/gp/product/B06XPFLNBS

If you're using S3D you can use the PETG profile that uses a single extruder to make frail supports and a strong model. I'f you're using S3D you can use the included fff profile file. If you're not using S3D, you can use Emma Puggle's support blocker at the link above. I used a Formbot Raptor 2 to print this, but these should be a good starting point.

Print Settings

Printer:

Formbot Raptor 2

Rafts:

No

Supports:

Yes

Resolution:

.2 layer height .4 nozzle

Infill:

20%

Filament:

Atomic PETG


Notes:

4 perimeters.

Category: 3D Printer Parts

Tagi