3D Sets Landy electronics box cover remix - removable seats

This is a modified electronics box cover for 3D Sets Landy model 3, that makes it possible to remove the seats in order to access electronics underneath, without disassembling half of the car ;)

There are 3 files:

• box is the main body - print once, in the same orientation as the original part
• seat_platform is the removable part on which the seats are mounted - print flat side down, once as it is and once mirrored to get both driver and passanger sides.
• plunger is the springloaded plunger/detent that holds the seat platform in place - you need one for each side, print pointing up

Other than the printed parts you will need two M3x6mm grub screws (the same as used to attach motor pinion to the motor) and one spring from a cigarette lighter, cut in half.

After printing you have to enlarge the opening on the bottom of the plungers to fit your spring, mine was 2.2mm. Next you insert the plunger into the plunger housing through the side opening, insert the spring through the rear opening, into which you finaly screw the grub screw.

I printed the base and the platforms with the 0.2mm layers, 15% gyro infill, 3 perimeters, 4 bottom and 5 top layers, no supports, sliced in Prusa Slicer 2.4.0

Print Settings

Printer:

Heavily modified Anet A8

Rafts:

Supports:

No

Resolution:

Infill:

15%

Filament:

PM PLA+

Black

Category: R/C Vehicles