Tinytag TGP-4104 temperature logger case

This model (3 parts) is a replacement case for the original case of these temperature loggers:

https://www.geminidataloggers.com/de/data-loggers/tinytag-plus-2/tgp-4104

The case design consists of three parts:

• The case which houses the electronics
• The lid, which is attached with four screws and sealed with an o-ring
• The bottom center connector where the usb cable is plugged in for configuration or download, which is sealed with a screw-on cap when not in use

Prerequisites:

• The original logger electronics and related components.
• I wasn't able to remove the USB connector sockets from the original case, so I had to get new sockets for the new case.
• Superglue

Assembly instructions:

• All components need obviously to be transferred over from the original case. Some parts are secured with glue which makes it somewhat difficult, just swear and pry.
• Solder wires on the new USB connector sockets.
• Install the sockets in the printed round USB connector and secure them with superglue.
• Install the connector in the case and secure it with superglue.
• Install the sensor connector (metal side connector) in the case using the original gasket and nut.
• Install the electronics, the nuts and the o-ring on the lid.
• Put the lid on and install the screws.
• Install the original label with the serial number on the side of the case in the recessed area.
• Print off and attach the provided logo pictures on the lid.

And there is a refurbished Tinytag available to continue logging…

Since the loggers are meant to be used in unpleasant environments it should be made from ABS, ASA, PETG or the likes of materials.