ToolkitRC M7 Charger replacement foot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stronger, simpler replacement feet for your M7 Charger
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 283
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Public Domain
The original feet on this device have two relief slots, which makes them way too flimsy. They almost seem as though they were engineered to fail. These replacements have just one slot so they're stronger yet still have enough flex to be easily installed.
Print in PLA with default settings and no supports. Orient so that the curved part of the foot is facing upward. The model includes tiny supports that were probably unnecessary. Snip them off before installation.
To install, insert at an angle and twist until the pins snap into place. They fold flat when not in use, just like the originals.