Beer holder/holster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
You will never forget where you left your beer again, with this beer holder attached to your belt!
- Ocena
- 0 / 5
- Polubienia
- 28
- Pobrania
- 170
- Wydruki
- 0
- Wyświetlenia
- 1018
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Share Alike
I made a different verison of great beer holster by Eric T. It is made to fit 0,5l bottles with diameter of 68mm (classic European bottle, at least in the Czech Republic), I also splitted it to 2 parts for better stiffness and easier printing.
You will need 4 additional M3x10 screws to attach the belt holder, it is easy to make another type of holder for another use. I added measurements between the four holes in the images.
I printed it from PLA with 0,25mm layer height, 3 perimeters and 20% infill and it works just fine.
Enjoy!