Numark PT-01 Tonearm by Flavour G'z

This is a Numark PT-01 tonearm by Flavour G'z from So Sharp Records.

Tonearm clip included.

Check post-print instructions of Vestax Handy Trax tonearm at

https://www.printables.com/model/308397-vestax-handy-trax-tonearm-by-flavour-gz

You need:

-1 2mm diameter x 4mm large spring

-1 m3x15 or 16mm bolt for spring tension adjustment

-2 m2x3 or 4 mm bolt without head for counterweight.

-Copper piece of 22mm diameter and 14mm height (around 60gr weight) or use 7 2€ coins with the specific counterweight for it.

Update:

Uploaded the tonearm files again, the first one could have problems, added a version with headshell attached and other version without print helper.

Print Settings

Supports:

Yes

Resolution: 

0.15

Infill:

100%

Notes:

The tonearm has another structure where the headshell goes to have better quality of print, just eliminate, after print.

tonearm: triangles support touching buildplate 20%

counterweight: grid support touching buildplate

headshell: print upside with zigzag support everywhere, first layer height 0.1, first layer concentric.

Post-Printing

Drill a little bit the holes on the tension adjust, the bolt needs to pass free.

Adjust the tonearm counterweight for 0gr balance without tension on the spring and then add tension to the spring, use a scale to get 3g-4g.

Check post-instructions at https://www.printables.com/model/308397-vestax-handy-trax-tonearm-by-flavour-gz