Printrite 2-in-1 fan duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printrite 2-in-1 fan duct
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 1
- Wyświetlenia
- 147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
2-in-1 fan duct for the printrite diy printer. This is the 3rd version wich i think is quite good and worth uploading here. Basically it directs some of the air flow from the fan in to the tip of the nozzle to cool the plastic coming out of it while still cooling the extruder. In my oppinion it helps a lot with overhangs.
I have set my fan to run 100% on all the time even when heating the extruder and had great results!
NOTE: This thing (may) lower the efficiency of cooling the extruder and cause little clogging but i let you to deside on that. (I am not very experienced in printing (yet) =)
Print Settings
Rafts:
Doesn't Matter
Supports:
Yes
Infill:
20%
Notes:
I recommend a fragile support type or otherwise the support is hard to get out of the inlet of the filament cooler. For example "lines" in cura engine worked very well. (The support is only needed for the screw mounts at the top.)
Post-Printing
Installation
Remove all support.
Unscrew the fan off the printer.
Screw the fan duct on the old place of the fan.
Mount the fan to the fan duct with two screws.
DONE!