Aquarium surface skimmer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based on surface skimmer by ArjitJangid (https://www.thingiverse.com/thing:2879673) but redesigned from scratch with…
- Ocena
- 5 / 5
- Polubienia
- 55
- Pobrania
- 243
- Wydruki
- 1
- Wyświetlenia
- 4633
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
Based on surface skimmer by ArjitJangid (https://www.thingiverse.com/thing:2879673) but redesigned from scratch with easier printing in mind.
Added a mounting point for Eheim 727110 suction cups (https://www.ebay.com/itm/190794265260). Also made the top closed as our turtle tends to push it down, and I don't want the fishes to end up in the filter.
The pipe that goes to the filter is 16mm outer diameter.
EDIT 2019-07-07: My previous "top" sank after a couple of days, updated "Print Settings" below with what I found works best after a lot of sinking ones... :)
Print Settings
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2
Infill:
20
Filament: add:north PETG Gray
Notes:
Housing and rod is printed according to these settings. Rod top might need a brim or raft depending on how good bed adhesion you have.
Top is printed in ~~PETG as well~~**PLA as it floats better**, with 0.4mm wall thickness, 0.6mm top/bottom thickness and ~~50%~~**40%** infill to make it float at the right height. This will depend on how powerful pump you have, so you might have to experiment a little but this is what works for me.Post-Printing
Just glue rod bottom and top together.
Category: Pets