Fred the Frog but a magnetically closed container.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A frog container with a magnetically attached head created from the resculpted Fred the Frog. Uses 6x2mm magnets.
- Ocena
- 0 / 5
- Polubienia
- 62
- Pobrania
- 157
- Wydruki
- 0
- Wyświetlenia
- 1681
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
I wasn't sure about printing the existing screw-fitting Fred container at large size and I thought it'd work well using magnets to attach the lid.
This is created from the “resculpted” version of Fred the Frog.
It requires eight 6x2mm magnets which should “push” fit into the holes with a tiny bit of force and then hold. If not you may need to widen the holes slightly and/or use a tiny dab of glue on the magnet.
To print it smaller you'd need to replace the magnet holes.
I originally intended to create a lip around the hole which would fit into a recession in the head for additional stability, but meshmixer did not want to co-operate.