Vase mode battery cases – AA, AAA, and CR123
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are simple battery (AA, AAA, CR123) holders. Fast print in vase mode with a 120% flow rate.
- Ocena
- 5 / 5
- Polubienia
- 47
- Pobrania
- 318
- Wydruki
- 12
- Wyświetlenia
- 1357
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
-– == Update 06/37/2023 == –
You may need to adjust x-y scale by +-/1-2% to account for the variation of battery sizes. I have printed 30+ holders and only had to do this one or two times.
–-== Original image ==--
-- == Vase-mode battery cases – AA, AAA, and CR123 == --
These are simple battery (AA, AAA, CR123) holders that you can toss in your gear bag. These are printed in vase mode with a 120% flow rate - see below. To release the batteries, just squeeze the case from the two ends and shake. The two battery holders can be tight, and it gets looser as the number of batteries goes up.
-- == Print Settings == --
Red+Black were printed in PLA, 0.4 Nozzle
VASE MODE (Spiralize Outside Contour in Cura)
Layer Height: 0.28
Line Width: 0.4
Bottom Layers: 3
Wall Flow: 120%
Bottom Flow: 105%
Cooling Fan: 100%
-- The CLEAR cases in the pictures were printed with transparent PETG. Same settings as above but increased temp +10 than normal PETG, and set the flow rate to 130% with the cooling fan OFF.