FDM Scope probe holder for lecroy PP00x probes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small triangular FDM print for holding an oscilloscope probe near-vertical above the board for easy hands-free probing.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 474
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a two part print for a small oscilloscope probe holder. I print it with 0.2mm layer height, with a 0.4mm nozzle, in PLA, without supports. The body is a 50mm wide triangle that the lecroy scope probe presses firmly into, and that supports the weight of the probe and cable for a reasonably stable base that still fits on medium-sized pcb's. The two press-in feet lift the body of the probe holder up enough that it can bridge over most small SMT components.
Opening the cylinder slot at the top and adding wall thickness would allow it to flex and possibly hold a wider array of probes.