Pico Squares - small speed squares
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small speed squares - 1½", 2½", 3½", 35mm, 60mm and 85mm basic carpenters layout squares aka speed squares.
- Ocena
- 4,889 / 5
- Polubienia
- 940
- Pobrania
- 2911
- Wydruki
- 37
- Wyświetlenia
- 8420
- Oceny
- 27
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
A blatant knockoff of Lee Valley's Veritas Pocket Squares (imperial and metric).
See https://www.leevalley.com/ for the real thing.
The tops are chopped off (for ease of printing) so they are actually 1 tick short (ie the 1½" square is actually 1 7/16" tall, the 35mm is 34mm tall).
These squares are quite accurate (printed on my i3 MK3 at 0.15mm layer height) - error no more than the width of a tick mark (distance and angles).
The measurements are from the inside of the hook (or base, ie measuring from the edge of a piece of wood) and the base is ⅛" thick (two ticks, inch) and 3mm thick (three ticks, metric).
My preferred printing orientation is as pictured - ruler to the print bed. If printed as modeled (base to print bed), the ruler ticks can become smooshed as melted plastic sags into the tick.
More on accuracy - “flash” on the edges can effect accuracy so pay attention to that. I checked them with a Mitutoyo machinist square and the 3½" was a bit out of square (the smaller ones were good). 150 grit sandpaper on a flat surface quickly made it light tight to the square.
A Brown & Sharpe adjustable protractor showed the smaller squares angles within a tick mark and the 3½" had about 1° of error.