Pan/Pot Lid Stand/Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple pan/pot lid stand/holder without supports and a good dripping tray for cooking spoons
- Ocena
- 4,714 / 5
- Polubienia
- 78
- Pobrania
- 501
- Wydruki
- 10
- Wyświetlenia
- 1932
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple pan/pot lid stand/holder for your cookware. It is compatible for lids with up to 30cm diameter, but it can be stretched if more balance is needed.
The original design is created by Lobsterdude. This model has been created by myself and adapted with higher pillars for a better balance of my heavy glas pot lid. In addition to some more rounded corners it can also be used as dripping tray for your cooking spoon.
This model does not require any supports.
Print settings
- Layer height: 0.2mm - 0.3mm
- Perimeters: 2
- Infill
- Density: 10% - 15%
- Pattern: Gyroid
- Suggested material: PLA, ABS, PETG, PC
I used PLA with a 0.6mm Nozzle, 0.3mm layer height, 2 perimeters, 15% infill density, gyroid pattern.
In Prusa Slicer 2.5.0 the estimated print time is 1 hour 43 minutes.