Walker skid foot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of @captmurphy's design (https://www.thingiverse.com/thing:4729843). Skid/foot changes Recessed the…
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 171
- Wydruki
- 1
- Wyświetlenia
- 611
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution
This is a remix of @captmurphy's design (https://www.thingiverse.com/thing:4729843).
Skid/foot changes
Recessed the screw hole to the full depth of the skid thickness, so that you can't wear the foot down to the point where the screw head is exposed.
Expansion plug changes
Up-sized by 10%. For my walker I found that the original plug fit inside the foot barrel without expanding it enough to grab the inside of the walker leg tube. My walker's tube is about 26mm ID.
Captured the nut by making a side slot and capping the top-side. This change allows the plug to be tapped out of the foot by loosening the screw a bit and tapping on it.
Printing
You'll probably want lots of solid thickness on the bottom of the foot to allow for wear without getting into infill. I printed the these with 30 bottom layers at 0.2mm layer thickness. I printed in PLA with supports on the front edge, rear edge, and in the screw hole. I tried ASA but the print failed due to leading edge of the foot pealing up, even with supports.
I printed the expansion plug with 5+ side walls and 50% infill so that it doesn't get crushed when tightened down.
Fusion360 files included.
Did you build it? Please leave a comment and rating.
If you really love it you're welcome to throw me a bone. Thank you. :)